Projector does not match xyz axis
(Resubmitting this bug, since it has been marked as outdated, but it still exists. Slight grammar and readability corrections.)
Stanislav Butenko shared this bug 2 years ago
Hi all.
I little bit confused with orientation of projector block. In all guides the cross on top of projector is up and vertical line is forward. If you check setting to show the grid pivot and compare orientation of single block in space of projector and cockpit you will find out that it's same, they are matching up the alignment. But... What is confusing me is why in controls of this block the horizontal and vertical offset control is reverted? If you place the projector with cross down and line in forward the control looks much understandable, plus goes right and minus left, plus goes up and minus down. Is it something wrong with the block orientation or do I not understand something?
I like this feedback
If I recall right, actual orientation is based on the first block placed in the entire grid.
But I agree. At some point. KEEN should go in and see if they can set a more streamlined projector. But it's a relatively minor issue, so I don't anticipate it getting much attention.
If I recall right, actual orientation is based on the first block placed in the entire grid.
But I agree. At some point. KEEN should go in and see if they can set a more streamlined projector. But it's a relatively minor issue, so I don't anticipate it getting much attention.
Replies have been locked on this page!