Bug: Oversized collision shape on 12.5 m Wheel Suspension

dealOne shared this bug 1 hour ago
Submitted

The largest Wheel Suspension (12.5 m) appears to have an oversized collision shape that extends approximately 2.5 m beyond the visible wheel geometry laterally.

This creates invisible collision barriers around the wheel.

Observed behavior

A vehicle equipped with this Wheel Suspension cannot enter a hangar even when the entrance is visibly wide enough and there appears to be plenty of clearance between the vehicle and the surrounding structure.

The vehicle gets blocked by an invisible collision boundary, despite there being no visible contact between the wheel and the hangar structure.

Expected behavior

The collision shape should closely match the actual physical geometry of the wheel and suspension, or at least remain within the visible wheel assembly's dimensions.

Impact

This makes it difficult or impossible to design and use hangars with reasonable clearance for vehicles equipped with the largest Wheel Suspension. The vehicle can get stuck at an entrance that is visually unobstructed.

screen with mesh in debug mode attached. This bug ruined my space transport project for vehicles. Internal part of sphere obstructing construction

This issue appears to affect all Wheel Suspension sizes, not just the largest 12.5 m variant.

Replies (1)

photo
1

additional picture

05fbe5b216587f866ebdd4066cef7f43

Leave a Comment
 
Attach a file