Space Engineers 2 Automation Reliability Bug Report
SummaryА заголовок для темы я бы оставила такой:I am experiencing unreliable automation behavior with Hinge blocks when using both Event Controllers and Timer Blocks in Space Engineers 2.
The most serious symptom is that an automation action can successfully change a Hinge’s Angular Velocity value (for example from -1 RPM to +1 RPM), but the Hinge sometimes does not physically move. On another run with the same setup, the same Hinge may work correctly while a different one fails.
The issue was reproduced repeatedly with a three-panel folding solar array using Hinge blocks on connected mechanical subgrids. Event Controller automation based on Hinge Angle was also unreliable, so I switched to Timer Blocks, but the problem remained intermittent.
Manual control of the same Hinges works correctly. Torque was increased to eliminate insufficient force as a cause, and the behavior still occurred.
I have attached a detailed report with the full setup, reproduction steps, observed states, test results, and screenshots.
Event Controller and Timer Block actions intermittently fail to move Hinges on mechanical subgrids
I like this feedback
Replies have been locked on this page!