The parameter value is correctly displayed in the control panel.
Submitted
I've noticed that in several block fields, when we modify a parameter, the value is saved and applied correctly, but it's not retained for display once we leave the block.
You can see this here with the LCD in the video. I set the size to over 100, it correctly takes the value, adjusts the display, and maintains the correct display, but when I go back to the value in the parameters, it's still at 100. Values below 100 are handled correctly.
I don't have an exact list for these same value problems on other blocks; I'll add them, or others, to the discussion later.
Files:
2026-08-19 17-4...
I have the same bug
Adding to the list, the hinge has a torque field and maximum angular limit which exhibit incorrectly displayed values, though the effect of the game is correct.
In the video, I install a new hinge to demonstrate that the problem exists from the installation stage, and I show that the rotation is correct on the first one, but each time the displayed values are incorrect.
Adding to the list, the hinge has a torque field and maximum angular limit which exhibit incorrectly displayed values, though the effect of the game is correct.
In the video, I install a new hinge to demonstrate that the problem exists from the installation stage, and I show that the rotation is correct on the first one, but each time the displayed values are incorrect.
Replies have been locked on this page!