Mirror bug placing light armor slope transition tip 0.5m
Not a Bug
In mirror mode:
When placing a light-armor-slope-transition-tip-0.5m it doesn't lead to a corresponding placement of a light-armor-slope-transition-tip-mirrored-0.5m peace on the other side of the red mirror plane.
A normal light-armor-slope-transition-tip-0.5m piece is used instead (which isn't the mirrored piece)
I have the same bug
Hello Dick Starmans,
This is expected behavior. Symmetry mode currently does not support mirroring other block variants such as the transition blocks.
As such, I will close this thread as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Hello Dick Starmans,
This is expected behavior. Symmetry mode currently does not support mirroring other block variants such as the transition blocks.
As such, I will close this thread as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!