Window slope and armor light slope 2.5m don't fit together
Not a Bug
I found a lot of discussion on the issue of blocks not able to share space, even though visually they look like they should. Perhaps you can find a way to make it possible to reflect reality in this case. I was trying to make the window airtight.
Files:
1133870_22.jpg
I have the same bug 
Hello Marko Ruban,
This is unfortunately a limitation of the cubical grid-based building, as the sloped parts of the block occupy half of the cubical cell and no other block can be placed in that specific cell.
As such, I will close this thread as a Not a Bug. However, feel free to post this as a feature request in our Feedback section.
Kind Regards,
Bartosz
Keen Software House
Hello Marko Ruban,
This is unfortunately a limitation of the cubical grid-based building, as the sloped parts of the block occupy half of the cubical cell and no other block can be placed in that specific cell.
As such, I will close this thread as a Not a Bug. However, feel free to post this as a feature request in our Feedback section.
Kind Regards,
Bartosz
Keen Software House
Thanks... I've seen this limitation mentioned on many occasions. Perhaps at some point the construction process can be re-evaluated to allow some such overlaps.
Thanks... I've seen this limitation mentioned on many occasions. Perhaps at some point the construction process can be re-evaluated to allow some such overlaps.
Replies have been locked on this page!