Grid power not connected to entire grid
Not a Bug
In Survial, I am having an issue where the batteries on the grid I just built are not supplying power to the survival kit, O2/H2 generator, and a light that are on the same grid.
I have batteries and solar panels on an adjacent wall to the survival kit, etc. I am wondering if this may be a connection issue between armor blocks where maybe the blocks arent logically connected despite them appearing to be visually connected. So perhaps it is acting as two separate grids is the only thing I can think of.
I have the same bug
After some troubleshooting, I am fairly certain the virtually single grid is more than one grid. I am not sure how this happened but I think maybe the armor blocks do not connect on more than one side as expected from SE1 behavior. The blocks appear to connect in one direction only.
After some troubleshooting, I am fairly certain the virtually single grid is more than one grid. I am not sure how this happened but I think maybe the armor blocks do not connect on more than one side as expected from SE1 behavior. The blocks appear to connect in one direction only.
placed blocks from right to left from the wall that the batteries touch, left most block shows no connection and cannot be welded until blocks on the right are welded first, despite there being a layer of blocks directly under these placed block projections.
placed blocks from right to left from the wall that the batteries touch, left most block shows no connection and cannot be welded until blocks on the right are welded first, despite there being a layer of blocks directly under these placed block projections.
Hello Razor,
This does look like there are more than one Grid in the picture. There are a few possible reasons for it, however, none of them is a bug.
If you feel that the current mechanics are confusing or unclear, please post about it in our Feedback section.
As the reported behavior is intended, I will close this thread as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Hello Razor,
This does look like there are more than one Grid in the picture. There are a few possible reasons for it, however, none of them is a bug.
If you feel that the current mechanics are confusing or unclear, please post about it in our Feedback section.
As the reported behavior is intended, I will close this thread as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!