Symmetry mode does not exit when removing block
Not a Bug
When I have a block on which I've entered symmetry mode.
When I attach some blocks to it, and then remove the middle block,
symmetry mode does not exit.
For example:
I have -[]- Where - is where blocks will be placed due to symmetry and [] is a block.
I build it like this:
1. -[]-
2. [][][]
3. []-[]
Step 3 now keeps a "ghost" symmetry mode open.
The screenshot shows what I am talking about.
Files:
Symmetry block...
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
Hello Bryan,
This is intended behavior. Symmetry does not disappear until the whole Grid to which it was applied to is deleted or destroyed. As such, even when deleting a block on which the Symmetry plane was first attached, the Symmetry plane will persist until all blocks from that Grid are deleted / destroyed. Please note however that blocks will not be placed on the other side of the Symmetry plane if the parts are not connected.
Please note that this mechanic is consistent with Space Engineers.
As such I will close this thread.
Kind Regards,
Bartosz
Keen Software House
Hello Bryan,
This is intended behavior. Symmetry does not disappear until the whole Grid to which it was applied to is deleted or destroyed. As such, even when deleting a block on which the Symmetry plane was first attached, the Symmetry plane will persist until all blocks from that Grid are deleted / destroyed. Please note however that blocks will not be placed on the other side of the Symmetry plane if the parts are not connected.
Please note that this mechanic is consistent with Space Engineers.
As such I will close this thread.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!