BUG 1.1.200.3846 Stair block not intuitive
Not a Bug
Hi SE2 Team!
I have noticed it is hard to place the stair block on another stair block, it does not align / does not detect the default position when aiming at the previously placed stair block and become not intuitive to play with.
Steps To Reprotduce
1 - Place a stair block on station floor.
2 - Have the stair block in hand ready to place a new one and aim at the top of the first stair block. to go to second floor for example so to make longer stair.
3 - Notice the Stair block you try to add does not want to auto-lock/auto-snap on default position, see from this image :
I have the same bug
Hello Daniel Dupuis,
This is intended behavior. By default, the stairs will snap it's downside to where your cursor is pointing, however with the Precision mode, aligning the stairs should be easy. As such I will close this thread.
Feel free to repost this as a feature request in our Feedback section.
Kind Regards,
Bartosz
Keen Software House
Hello Daniel Dupuis,
This is intended behavior. By default, the stairs will snap it's downside to where your cursor is pointing, however with the Precision mode, aligning the stairs should be easy. As such I will close this thread.
Feel free to repost this as a feature request in our Feedback section.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!