[SE2] Event Controller: Compared Value not Saved
Reported
Actions:
1. Open Grid Control Panel
2. Select Event Controller
3. Set Parameter to "Block Piston Distance" or "Block Hinge Angle"
4. Add Block Piston or Hinge
5. Set Comparison Mode to "Greater Than"
6. Set Compared value to anything but 0.0
7. Click somewhere or press enter
8. Close Grid Screen (x)
Issue:
The "Compared Value" is not saved or resets to 0.0
I have the same bug
Hello BBex,
I have reported this issue internally and attached this thread to our internal ticket (SE2-34003).
Please note that the Compared Value is not saved only when it is the only change made in the Event Controller terminal before closing the terminal. Switching to another block and back to the EC causes the Compared Value to be saved correctly
Kind Regards,
Bartosz
Keen Software House
Hello BBex,
I have reported this issue internally and attached this thread to our internal ticket (SE2-34003).
Please note that the Compared Value is not saved only when it is the only change made in the Event Controller terminal before closing the terminal. Switching to another block and back to the EC causes the Compared Value to be saved correctly
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!