Cannot attach rotor head if subgrids share a common grid
Not a Bug
It appears that you cannot attach a rotor head to a rotor if the attaching has a parent of the same base grid. I.e. Cycles of connected grids do not appear to work.
I call this a bug, because it was something that could be done in SE1 and the ability to create parallel linkages is important from some simple but useful mechanical linkages. E.g. A scissor lift or underactuated adaptable gripper assembly. These both require that pairs or cycles of pivot points be allowed to connect in a loop to create a specific motion.
example: https://www.youtube.com/shorts/1ziQGQiweF8
And the most common of all use cases for SE1 or 2, a door with two rotors/hinges.
I have the same bug You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
Hello Meatball,
This is expected behavior currently. A Grid cannot be connected to more than 1 mechanical block top part and attached to the mechanical block. This will be implemented in future updates.
As such, I will close this thread as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Hello Meatball,
This is expected behavior currently. A Grid cannot be connected to more than 1 mechanical block top part and attached to the mechanical block. This will be implemented in future updates.
As such, I will close this thread as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!