Need a 1.25x1.25x2.5 block
Not a Bug
I found that the Large and small blocks have sort of a hindrance with being compatible. It takes 2.5 50mm blocks to make 1/2 of a large block. That means tons of decorative blocks to fill in gaps. I find myself using the 1.25x1.25x2.5 triangular block and turning it on its side to fill the gap and just leaving a gap underneath/inside.
in contrast that filler is 50PCU to fill that block up properly. Attached is a screenshot. I built the "filler" I needed. It is literally 50PCU. I then attached the angle piece on it for reference. Would be nice to have the block in question to cut 49 PCU off the builds.
Files:
Blocks.png
I have the same bug 
You can't vote. Please authorize!
Hello Dirk,
As this is a feedback rather than a bug, I will close this thread.
Please repost this as a feature request in our Feedback section.
Kind Regards,
Bartosz
Keen Software House
Hello Dirk,
As this is a feedback rather than a bug, I will close this thread.
Please repost this as a feature request in our Feedback section.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!