Connector block strength "default" value
Submitted
The initial value of the Connector block's strength slider is 0.015%.
Right-clicking sliders normally sets them to their default value, but for Connector strength this value is confusingly set to 0.0002%. At this strength the effect is barely perceptible even in zero grav and close enough to Disabled (0%) that it's not a meaningful difference.
I think it would be preferred for the Connector if the right-click value would be the same as the initial value of 0.015%, though any value higher than 0.01% would not be inconvenient.
I like this feedback
Replies have been locked on this page!