[suggetion] Solar & Wind Turbine

ズホエンデルカ shared this feedback 12 hours ago
Not Enough Votes

The current specification is that the total power consumption of the battery and functional blocks is the maximum value of the solar and wind turbine "Current Output".

バッテリーや機能ブロックの合計消費電力が、ソーラーとウィンドタービンの"Current Output"の最大値となってしまうのが現在の仕様です。


I had thought that the "Power Output" of the event controller would be used mostly to detect fluctuations in solar and wind turbine power, but since I was using very few function blocks, once the battery reached its maximum capacity, the event controller would alternate between on and off, making it impossible to use a single event controller accurately for these purposes.

イベントコントローラの”Power Output"を使用するケースはおおよそソーラーとウィンドタービンの変動を探知するものだと考えていましたが、機能ブロックをほとんど使用しておらず、バッテリーが最大値まで溜まってしまうと、イベントコントローラはOn/Offを交互に繰り返す状態となってしまい、これらの用途では正確に使用することはイベントコントローラ1つでは不可能です。


Is it possible to change the specifications so that "Current Output" is set to the normal power generation value instead of "0W" even if there is no destination for solar and wind turbine power, so that the event controller functions can be used normally?

イベントコントローラの機能を正常に利用できるように、ソーラーとウィンドタービンの電力の送り先がなくても、"Current Output"を"0W"とせずに通常発電の値とする仕様に変更できませんか?


My English is not very good, so I am using Google Translate. I apologize if my comments are difficult to understand.

私の英語が未熟であるため、グーグル翻訳を利用しております。分かりづらい発言になっていた場合、申し訳ありません。

Leave a Comment
 
Attach a file