About Projectors and Welders
Hello. Just a small suggestion here, regarding welding projected large ship grid blueprints using welders. As it is now, when welding such blueprint, welders will immediately create any block that can be attached to already existing (physical) parts of blueprints, and start welding it. But since newly created blocks often have attachable surfaces too, welder will immediately create new blocks and weld them, leaving previous blocks mostly unfinshed and now obstructed by newly created ones.
This has been major headache when building something large, so here's my suggestion: add a toggle to projector block, that prevents welders from "starting" new blocks until already started blocks (those who's frames were places, e.g. build progress not at 0%) are welded to 100%. This way you can weld blueprints somewhat slower, but almost certainly not going to miss any block left deep inside the ship/station, that was left unfinished.
Thanks.
I like this feedback
Replies have been locked on this page!